Miss Monday Cards-So Sentimental

 

Miss Monday Cards with the retiring So Sentimental stamp set! This great stamp is getting ready to retire on May 3rd, 2021 and so I knew I needed to use it before it wasn't available to show you how wonderful it is! 

Below is the link for the bundle with this stamp set. 

https://www.stampinup.com/products/so-sentimental-bundle-(en)?demoid=2130375

I made two cards with just two differences. Can you spot them? (answers below)

The Fun part of this stamp set is that it has dies that go along perfectly with them, the Stitched So Sweetly Dies. Those are NOT retiring and you will see them again in the next catalog. I used 3 dies and cut them all out of that first big image. 

https://www.stampinup.com/products/stitched-so-sweetly-dies?demoid=2130375

Be sure to carry over the confetti theme to the inside of the card. I left the center blank so it could be used for Birthdays or anything you would celebrate! 

This one I kept really simple and didn't stamp the confetti on the front and only used dimensionals for the scalloped border piece. 

This one I added the confetti under the word confetti and used dimenionals to pop up the center label. 

You can make this card too by visiting my online store and following the steps below. 

Supplies

*So Sentimental Stamp Set

Stitched So Sweetly Dies

*Fine Art Floral DSP

Smoky Slate Cardstock

Pool Party Cardstock

Basic White Cardstock

*Pretty Peacock Ink

*Retiring on May 3rd

Always Recommended

Paper Snips

Trimmer

Simply Shammy

Die Cutting Machine

Bone Folder

Adhesives

Measurements

Smoky Slate Cardbase: 5 1/2 x 8 1/2 scored @ 4 1/4

DSP & Basic White: 4 x 5 1/4

Steps

1. Measure, score, and cut your paper. 
2. Die cut in Pool Party 3 times with the Stitched So Sweetly dies. You could even run them through your Stampin' Cut & Emboss machine all at the same time. 
3. Stamp in Pretty Peacock on the smallest label and confetti stamp on the inside of the card on the basic white. 
4. Glue the DSP to the card front and basic white to the inside. 
5. Attach the scalloped outline with dimensionals and choose if you want the label to lay flat with glue or popped up with dimensionals. 

Happy Stampin' Everyone!!!