Sale-a-bration & Peaceful Deer

 

I made this card for my Stamp Camp swap! I needed something fast and something that showed off some new products and used something from Sale-a-bration. This Peaceful Prints and Peaceful Dear stamp set and punch was the winner! 

To create the deer in two different directions you just have to flip over the DSP before you punch. One right side up and one wrong side up and then flip it to attach! 

This card was actually inspired by a tag I found in the Sale-a-bration flyer. I took that tag look and made it into a full size card. You can make this card too but shopping from my online store during Sale-a-bration and following the steps below. 

Supplies

Peaceful Deer stamp set

Deer Punch

SAB Peaceful Prints DSP

Wintry 3D Embossing Folder

Ink- Garde Green, Early Espresso, Sahara Sand

Paper- Real Red, Early Espresso, Basic White

Always Recommended

Paper Snips

Trimmer

Simply Shammy

Die Cutting Machine

Bone Folder

Adhesives: Tombow, Tear Tape, Seal, & Dimensionals

Measurements

Real Red Cardbase: 5 1/2 x 8 1/2 scored @ 4 1/4

Basic White: 4 x 5 1/4

DSP: 4 1/4 x 4

DSP: 3 3/4 x 3 3/4

Early Espresso: 3 7/8 x 3 7/8

Steps

1. Measure, score, and cut your paper. 
2. Stamp in Early Espresso your greeting onto the DSP and the trees in Garden Green.
3. Sponge the DSP with Sahara Sand and glue to the Early Espresso matte. 
4. Glue the 4 1/4 x 4 DSP onto the cardbase. 
5. Use Dimensionals to attach the DSP square. 
6. Punch out 2 deer from the DSP. Flip over the DSP to the wrong side up to get the heads going two different directions. 
7. Emboss a quarter of the Basic White and glue to the inside of the card. 

Happy Stampin' Everyone!!!