Fun Fold Friday- Sliding Driving By

Fun Fold Friday with a Slider card using Sale-a-bration stamp set, Driving By and Sale-a-bration DSP, Sunshine & Rainbows! 

 

The card will start out in this position. 

It isn't until you pull the tag that you see the fun message! 

To create the slider "track" I had to use a die from the All Dress Up Dies but it is too long for the space that I needed. So I used washi tape to mark 3 1/2 on the die and then lined up my top plate edge to that spot. This way it only cuts where I want it to. Then once I pull it out of the Die Cut & Embossing machine all I had to do is cut the end the didn't get cut. See my video below for more details. 

I just love how I used the DSP to make this Volkswagen Bus just a little more fun! Watch my video to see how easy it is to change the bus design with DSP and a pair of snips! 

Supplies

Driving By Sale-a-bration Stamp Set

Brilliant Rainbow Dies (clouds)

All Dressed Up Dies

Sunshine & Rainbows DSP

Paper- Basic Black, Costal Cabana, Basic White

Stampin' Blends- Mango Melody, Smokey Slate

Adhesive Strips

Delightful Tag Topper

Sheer Pool Party Ribbon 

Mini Dimensionals

Versamark & White Embossing Powder

Memento Tuxedo Black Ink

Always Recommended

Paper Snips

Trimmer

Simply Shammy

Die Cutting Machine

Bone Folder

Adhesives: Tombow, Tear Tape, Seal, & Dimensionals

Measurements

Costal Cabana Cardbase: 5 1/2 x 8 1/2 scored @ 4 1/4

Basic Black: 4 x 5 1/4

2 x 5 1/2

1 1/4 x 5

DSP: 3 3/4 x 5

Basic White: 4 x 5 1/4

scraps to stamp bus onto

Steps

1. Measure, score, and cut your paper. 
2. Line up your DSP with the Basic Black strip and die cut together to make the "track". See video or photo above to see how. Remove the middle strip with snips and then glue the two pieces together. 
3. Use the Tag Topper on the Basic Black 2 x 5 1/2 and stamp your saying in Versamark top left of where you punched out. 
4. Die cut out 3 to 4 clouds with the Basic White and glue to your DSP. 
5. Stamp in Memento Ink the Bus onto Basic White and onto your DSP of choice. Fussy cut out just the center of the DSP of the bus and glue it onto the Basic White Bus. Fussy cut them both out and color the bus with Stampin' Blends (see video). 
6. Measure your adhesive foam strips at 5 inches and one at 2 inches. Flip your DSP over and attach them one at the bottom of the track, above the track (use punched out Basic Black to help you measure) and one at the top of the DSP. Then at the end of the track add the 2 inch foam as a "stopper". 
7. Glue the Basic Black matte to the card front and attach the foam backed DSP to the Basic Black. 
8. Slide the tag topper all the way through the track and put 2 mini dimensionals on the very end. Attach the van to those dimensionals. 
9. Use some Pool Party ribbon at the end of the tag, 

Facebook Live Video

Happy Stampin' Everyone!!!